GP-7 SRC

Arai GP-7 SRC

FIA Standard 8860-2018 GP-7 SRC

To begin with, there is some very important information we want you to know about Arai helmets used in racing. From the top of F1, where we have been consistently involved since 1984, to the karting championships, through all the intermediate categories, Arai does not create custom "racing helmets" for drivers. The Arai helmets you can see on track, worn by any rider in any category, are the same ones available at your trusted Arai dealer. The technical features and performance levels achieved by our helmets on the world's most prestigious race tracks are the product of deep dedication and an unwavering commitment to Protection, refined through decades of experience: there are no shortcuts. 
Simply. 

FIA Standard 8860-2018 GP-7 SRC

The new GP-7 SRC is the absolute masterpiece capable of combining Arai engineering, performance and comfort at the highest levels. It complies with the new FIA 8860-2018 standard, intended to be the safest in the world of high-end helmets used in motor racing, as well as an advancement in terms of protection compared to the previous FIA 8860-2010. The key to the GP-7 SRC's incredible performance is its outer shell, constructed with a completely internally developed carbon fiber (CF) fabric that combines the high strength and extreme lightness advantages of carbon, with the advantage that standard carbon fibers do not have to be extremely flexible (standard fibers tend to splinter or break rather than flex on impact). 

The result is a helmet capable of meeting and exceeding the demands of the world's most demanding riders.The list of technical features and technologies included in GP-7SRC is impressive because, for this helmet and its potential user, it simply has to be.

GP-7 SRC

It is capable of withstanding 225 grams of weight while traveling at 250 km/h. Note that the GP-7 SRC leaves the factory without the upper air intakes (vents are left open).Each package will contain a package with various types of vents so the rider can choose the most suitable one based on riding position and preference. Below are the components included: 

- PED (Performance Enhancement Device) kit (front and rear spoiler assembly). 
- Screw kit (4 x torx, 4 x washer and 1 x pressure plate set) 
- Vent Kit (7 x Tear Vent, 2 x TDF3, 1 x XDB2) 
- Rear anchor assembly 
- Torx screwdriver (T20) 
- Sticker set (2 x 11 cm, 2 x 9 cm with masking film for custom design, 2 x 5.5 cm)